Bridge-Group Bpdufilter Command (Ppp Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
bridge-group <group#> bpdufilter [enable | disable]
Use the bridge-group bpdufilter command to block BPDUs from being transmitted and received on this
interface. To return to the default value, use the no form of this command.
Syntax Description
<group#>
enable
disable
Default Values
By default, this command is set to disable.
Applicable Platforms
This command applies to the NetVanta 5000 Series units.
Command History
Release 5.1
Functional Notes
The purpose of this command is to remove a port from participation in the spanning tree. This might be
beneficial while debugging a network setup. It normally should not be used in a live network.
Usage Examples
The following example enables the BPDU filter on the interface:
(config)#interface ppp 1
(config-ppp 1)#bridge-group 1 bpdufilter enable
61200990L1-35E
Assigns a bridge group number (range: 1 to 255).
Enables the BPDU filter.
Disables the BPDU filter.
Command was introduced.
Copyright © 2005 ADTRAN
PPP Interface Configuration Command Set
891