Speed - Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
speed [10 | 100 | auto | nonegotiate]
Use the speed command to configure the speed of an Ethernet interface. Use the no form of this command
to return to the default value.
Syntax Description
10
100
auto
nonegotiate
If the speed is manually set to 10 or 100, the duplex must be manually configured as
full-duplex or half-duplex.
Default Values
By default, speed is set to auto.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000
and Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example configures the Ethernet port for 100 Mb operation:
(config)#interface ethernet 0/1
(config-eth 0/1)#speed 100
61200990L1-35E
Specifies 10 Mbps Ethernet.
Specifies 100 Mbps Ethernet.
Automatically detects 10 or 100 Mbps Ethernet and negotiates the duplex setting.
Disables auto negotiation and forces the speed to 1 Gbps. This only applies to
Gigabit Ethernet interfaces.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
589