Show Ip Igmp Interface Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show ip igmp interface <interface>
Use the show ip igmp interface command to display multicast-related information per-interface. If no
interface is specified, this command shows information for all interfaces.
Syntax Description
<interface>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 7.1
Release 9.1
Usage Examples
The following is sample output from this command:
>enable
#show ip igmp interface
eth 0/1 is UP
Ip Address is 10.22.120.47, netmask is 255.255.255.0
IGMP is enabled on interface
Current IGMP version is 2
IGMP query interval is 60 seconds
IGMP querier timeout is 120 seconds
IGMP max query response time is 10 seconds
Last member query count is 2
Last member query response interval is 1000 ms
IGMP activity: 548 joins, 0 leaves
IGMP querying router is 0.0.0.0
IGMP helper address is disabled
61200990L1-35E
Displays information for a specific interface (in the format type slot/port). Enter the
show ip igmp interface ? command for a complete list of interfaces.
Command was introduced.
Command was expanded to include HDLC and tunnel interfaces.
Copyright © 2005 ADTRAN
Enable Mode Command Set
206