Connect-Sequence Attempts Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
connect-sequence attempts <value>
Use the connect-sequence attempts command to limit the number of times the connect sequence will
cycle when its entries are unable to establish a connection. When the maximum number of attempts are
exhausted, the interface will go into recovery mode. Refer to connect-sequence interface-recovery
[retry-interval <seconds> | max-retries <value>]
this command to restore the default values.
Syntax Description
<value>
Default Values
By default the connect-sequence attempts are unlimited.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 11.1
Usage Examples
The following example instructs demand interface 1 to attempt its connection sequence 500 times:
(config)#interface demand 1
(config-demand 1)#connect-sequence attempts 500
61200990L1-35E
Specifies the number of times the connect sequence will cycle through its entries
if it is unable to make a connection. Range is 0 to 65,535.
Command was introduced.
Copyright © 2005 ADTRAN
Demand Interface Configuration Command Set
on page 644 for more information. Use the no form of
643