Tacacs + Group Configuration Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
TACACS+ G
ROUP
To activate the Terminal Access Controller Access Control System Plus (TACACS+) Group
Configuration mode, enter the aaa group server tacacs+ command at the Global Configuration mode
prompt. For example:
>enable
#configure terminal
(config)#aaa group server tacacs+ TEST GROUP
(config-sg-tacacs+)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
server <host> on page 1192
61200990L1-35E
C
ONFIGURATION
Copyright © 2005 ADTRAN
TACACS+ Group Configuration Command Set
C S
OMMAND ET
1191