Show Qos Map Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show qos map
The show qos map command outputs information about the quality of service (QoS) map. This
information differs based on how a particular map entry is defined.
Variations of this command include the following:
show qos map
show qos map <map name>
show qos map <map name> <sequence number>
show qos map interface <interface id>
Syntax Description
<map name>
<sequence number>
<interface id>
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 6.1
Release 9.1
Release 11.1
61200990L1-35E
Specifies the name of a defined QoS map.
Specifies one of the map's defined sequence numbers.
Displays the QoS map information for a specific interface (e.g., Frame Relay,
PPP, or ATM). Enter the show qos map interface ? command for a complete list
of interfaces.
Command was introduced.
Command was expanded to include HDLC interface.
Demand interface was added.
Copyright © 2005 ADTRAN
Enable Mode Command Set
245