Test-Pattern - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
test-pattern [clear | insert | ones| p215 | p220 | p511 | qrss | zeros]
Use the test-pattern command to activate the built-in pattern generator and begin sending the specified
test pattern. This pattern generation can be used to verify a data path when used in conjunction with an
active loopback. Use the no form of this command to cease pattern generation.
Syntax Description
clear
insert
ones
p215
p220
p511
qrss
zeros
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 5.1
Usage Examples
The following example activates the pattern generator for a stream of continuous ones:
(config)#interface e1 1/1
(config-e1 1/1)#test-pattern ones
61200990L1-35E
Clears the test pattern error count.
Inserts an error into the currently active test pattern. Display the injected error
result using the show test-pattern command.
Generates test pattern of continous ones.
Generates a pseudorandom test pattern sequence based on a 15-bit shift register.
Generates a pseudorandom test pattern sequence based on a 20-bit shift register.
Generates a test pattern of repeating ones and zeros.
Generates a test pattern of random ones and zeros.
Generates test pattern of continous zeros.
Command was introduced.
Copyright © 2005 ADTRAN
E1 Interface Configuration Command Set
525