Line Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
line [console | telnet | ssh] <line-number> <ending number>
Use the line command to enter the line configuration for the specified console, Telnet, or secure shell
(SSH) session. Refer to the sections Line (Console) Interface Config Command Set
(Telnet) Interface Config Command Set
page 483 for information on the subcommands.
Syntax Description
console
telnet
ssh
<line-number>
<ending number>
Default Values
By default, the AOS line console parameters are configured as follows:
Data Rate: 9600
Data bits: 8
Stop bits: 1
Parity Bits: 0
No flow control
By default, there are no configured Telnet or SSH sessions.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
61200990L1-35E
on page
Enters the configuration mode for the DB-9 (female) CONSOLE port located on the
rear panel of the unit. Refer to the sections
Command Set on page 816
command set.
Enters the configuration mode for Telnet session(s), allowing you to configure for
remote access. Refer to the section
on page 491 for information on the subcommands found in that command set.
Enters the configuration mode for SSH. Refer to the section
Config Command Set on page 483
that command set.
Specifies the starting session to configure for remote access (valid range for
console: 0; valid range for Telnet and SSH: 0 to 4).
If configuring a single Telnet or SSH session, enter the session number and leave
the <ending number> field blank.
Optional. Specifies the last Telnet or SSH session to configure for remote access
(valid range: 0 to 4).
For example, to configure all available Telnet sessions, enter line telnet 0 4.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
491, and Line (SSH) Interface Config Command Set
Line (Console) Interface Config
for information on the subcommands found in that
Line (Telnet) Interface Config Command Set
for information on the subcommands found in
on page 470, Line
on
Line (SSH) Interface
413