Dial-Backup Restore-Delay Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
dial-backup restore-delay <seconds>
Use the dial-backup restore-delay command to configure the amount of time the router will wait after the
network is restored before disconnecting the backup link and reverting to the primary. This setting is used
to prevent disconnecting the backup link if the primary link is "bouncing" in and out of alarm. For more
detailed information on Frame Relay dial-backup functionality, refer to the Functional Notes and
Technology Review sections of the command dial-backup call-mode [answer | answer-always | originate |
originate-answer | originate-answer-always]
Syntax Description
<seconds>
Default Values
By default, dial-backup restore-delay is set to 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 1.1
Usage Examples
The following example configures the AOS to wait 30 seconds before disconnecting dial-backup operation
and restoring the primary connection for this endpoint:
(config)#interface frame-relay 1.16
(config-fr 1.16)#dial-backup restore-delay 30
61200990L1-35E
on page
Specifies the number of seconds the AOS will wait (after a primary link is restored)
before disconnecting dial-backup operation. Range: 10 to 86,400.
Command was introduced.
Copyright © 2005 ADTRAN
Frame Relay Sub-Interface Config Command Set
725.
735