Match Ip Precedence Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
match ip precedence [<value> | critical | flash | flash-override |
immediate | internet | network | priority | routine]
Use the match ip precedence command to configure the route map to route traffic based on the
precedence value in the IP header of the packet. Use the no form of this command to discontinue matching.
Syntax Description
<value>
routine
priority
immediate
flash
flash-override
critical
internet
network
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 Series, and Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example instructs the route map named MyMap to match the IP precedence value of
critical:
(config)#route-map MyMap permit 100
(config-route-map)#match ip precedence critical
61200990L1-35E
Specifies matching the IP precedence (in numeric value). (Valid range:
0 to 7 in ascending order of importance.)
Specifies matching the IP precedence routine. (Numeric value of 0.)
Specifies matching the IP precedence priority. (Numeric value of 1.)
Specifies matching the IP precedence immediate. (Numeric value
of 2.)
Specifies matching the IP precedence flash. (Numeric value of 3.)
Specifies matching the IP precedence flash-override. (Numeric value
of 4.)
Specifies matching the IP precedence critical. (Numeric value of 5.)
Specifies matching the IP precedence internet. (Numeric value of 6.)
This level is reserved for internal network use.
Specifies matching the IP precedence network. (Numeric value of 7.)
This level is reserved for internal network use.
Command was introduced.
Copyright © 2005 ADTRAN
Route Map Command Set
1177