Show Tcp Info Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show tcp info [realtime] <control block>
Use the show tcp info command to display Transmission Control Protocol (TCP) control block
information in the AOS. This information is for troubleshooting and debug purposes only. For more
detailed information, you can optionally specify a particular TCP control block. When a particular TCP
control block is specified, the system provides additional information regarding crypto map settings that
the show tcp info command does not display.
Syntax Description
realtime
<control block>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 4.1
Release 10.1
Function Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
276
).
Usage Examples
The following is a sample from the show tcp info command:
>enable
#show tcp info
TCP TCB Entries
61200990L1-35E
Displays full-screen output in real time. See the Functional Notes below for more
information.
Optional. Specifies a particular TCP control block for more detailed information.
Command was introduced.
The real time display option was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
terminal length <text> on page
267