Show Lldp Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Enable Mode Command Set
show lldp
Use the show lldp command to display local loop demarkation point (LLDP) timer configuration.
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 8.1 Command was introduced.
Usage Examples
The following example shows a sample LLDP timer configuration:
>enable
#show lldp
Global LLDP information:
Sending LLDP packets every 30 seconds
Sending TTL of 120 seconds
61200990L1-35E Copyright © 2005 ADTRAN 231