ADTRAN 5000 Series Command Reference Manual page 528

Command Reference Guide
Not all Ethernet commands apply to all Ethernet types. Use the ? command to display a list
of valid commands. For example:
>enable
Password:xxxxx
#config term
(config)#int eth 0/1
(config-eth 0/1)#?
access-policy
alias
arp
bandwidth
bridge-group
etc....
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 27
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
arp arpa on page 533
bandwidth <value>
bridge-group <group#>
crypto map <mapname>
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password>
page 538
encapsulation 802.1q
full-duplex on page 541
half-duplex on page 543
ip commands begin on page 544
61200990L1-35E
- Assign access control policy for this interface
- A text name assigned by an SNMP NMS
- Set ARP commands
- Set bandwidth informational parameter
- Assign the current interface to a bridge group
on page 31
on page 530
on page 534
on page 535
on page 536
on page 540
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
on
528