Loopback Remote Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
loopback remote [line | payload]
Use the loopback remote command to initiate a loopback test on the T3 interface that sends a remote
loopback code out the T3 circuit to loop up the far end. This command only applies when C-bit framing is
used on the circuit. Use the no form of this command to deactivate the loopback.
Syntax Description
line
payload
Default Value
No default value is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 5000 Series.
Command History
Release 6.1
Usage Examples
This example initiates a remote loopback on the T3 interface:
(config)#interface t3 1/1
(config-t3 1/1)#loopback remote
61200990L1-35E
Initiates a line loopback.
Initiates a payload loopback.
Command was introduced.
Copyright © 2005 ADTRAN
T3 Interface Configuration Command Set
626