Pppoe Ac-Name (Ppp Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
pppoe ac-name <name>
Use the pppoe ac-name command to identify the Access Concentrator (AC) with which the AOS expects
to establish a PPPoE session. Use the no form of this command to return to the default setting.
Syntax Description
<name>
Default Values
By default, no AC is specified.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1
Usage Examples
The following example identifies the AC with which the AOS expects to establish a PPPoE session:
(config)#interface ppp 1
(config-ppp 1)#pppoe acc-name Access_Concentrator_Name
61200990L1-35E
Specifies an AC by text string (up to 255 characters) corresponding to the
AC-Name Tag under RFC2516. If this field is not specified, any access
concentrator is acceptable. The AC value may be a combination of trademark,
model, and serial ID information (or simply the MAC address of the unit).
Command was introduced.
Copyright © 2005 ADTRAN
PPP Interface Configuration Command Set
961