Lldp Receive (Tunnel Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Tunnel Configuration Command Set
lldp receive
Use the lldp receive command to allow LLDP packets to be received on this interface.
Syntax Description
No subcommands.
Default Values
By default, all interfaces are configured to send and receive LLDP packets.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 9.1 Command was introduced.
Usage Examples
The following example configures the tunnel interface to receive LLDP packets:
(config)#interface tunnel 1
(config-tunnel 1)#lldp receive
61200990L1-35E Copyright © 2005 ADTRAN 1017