Show Sntp Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Enable Mode Command Set
show sntp
Use the show sntp command to display the system Simple Network Time Protocol (SNTP) parameters and
current status of SNTP communications.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1 Command was introduced.
Usage Examples
>enable
#show sntp
61200990L1-35E Copyright © 2005 ADTRAN 260