Arp Arpa - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide

arp arpa

Use the arp arpa command to enable address resolution protocol (ARP) on the Ethernet interface.
Syntax Description
arpa
Default Values
The default for this command is arpa.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and Total Access
900 Series units.
Command History
Release 3.1
Release 5.1
Usage Examples
The following example enables standard ARP for the Ethernet interface:
(config)#interface eth 0/1
(config-eth 0/1)#arp arpa
61200990L1-35E
Sets standard address resolution protocol for this interface.
Command was introduced.
Command was expanded to include Ethernet sub-interfaces and Gigabit Ethernet
interfaces.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
533