Ppp Interface Configuration Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
PPP I
NTERFACE
To activate the PPP Interface Configuration mode, enter the interface ppp command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface ppp 1
(config-ppp 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
alias link<"text">
bandwidth <value>
bridge-group commands
crypto map <mapname>
dial-backup commands
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password> on page 915
fair-queue <threshold>
hold-queue <queue size> out
ip commands begin on page 919
keepalive <seconds>
lldp receive on page 946
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive]
61200990L1-35E
C
ONFIGURATION
on page 31
on page 885
on page 888
on page 889
begin on page 890
on page 896
begin on page 898
on page 917
on page 918
on page 945
on page 947
Copyright © 2005 ADTRAN

PPP Interface Configuration Command Set

C S
OMMAND ET
883