Loopback Interface Configuration Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
L I
OOPBACK NTERFACE
To activate the Loopback Interface Configuration mode, enter the interface loopback command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface loopback 1
(config-loop 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
bandwidth <value>
crypto map <mapname>
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password>
page 853
ip commands begin on page 855
ip commands begin on page 856
mtu <size> on page 880
snmp trap on page 881
snmp trap link-status
61200990L1-35E
C
ONFIGURATION
on page 31
on page 847
on page 850
on page 851
on page 882
Copyright © 2005 ADTRAN

Loopback Interface Configuration Command Set

C
OMMAND
S
ET
on
846