Ip-Range Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip-range <start ip> <end ip>
Use the ip-range command to specify the range of addresses from which the router draws when assigning
an IP address to a client.
Syntax Description
<start ip>
<end ip>
Default Values
By default, no IP address range is defined.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
Usage Examples
The following example defines an IP address range for this configuration pool:
(config)#crypto ike client configuration pool ConfigPool1
(config-ike-client-pool)#ip-range 172.1.1.1 172.1.1.25
61200990L1-35E
Specifies the first IP address in the range for this pool.
Specifies the last IP address in the range for this pool.
Command was introduced.
Copyright © 2005 ADTRAN
IKE Client Command Set
1065