Crypto Map - Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
crypto map <mapname>
Use the crypto map command to associate crypto maps with the interface.
When you apply a map to an interface, you are applying all crypto maps with the given
map name. This allows you to apply multiple crypto maps if you have created maps which
share the same name but have different map index numbers.
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.
Syntax Description
<mapname>
Default Values
By default, no crypto maps are assigned to an interface.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 4.1
Release 11.1
Functional Notes
When configuring a system to use both the stateful inspection firewall and IKE negotiation for VPN, keep
the following notes in mind.
When defining the policy class and associated access-control lists (ACLs) that describe the behavior of the
firewall, do not forget to include the traffic coming into the system over a VPN tunnel terminated by the
system. The firewall should be set up with respect to the unencrypted traffic that is destined to be sent or
received over the VPN tunnel. The following diagram represents typical AOS data-flow logic.
61200990L1-35E
Assigns a crypto map name to the interface.
Command was introduced.
Command expanded to include the demand interface.
Copyright © 2005 ADTRAN
Demand Interface Configuration Command Set
645