Transform-Set (Crypto Map Manual Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
set transform-set <setname>
Use the set transform-set command to assign a transform set to a crypto map. See crypto ipsec
transform-set <setname> <parameters>
Syntax Description
<setname>
Default Values
By default, no transform set is assigned to the crypto map.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 Series units.
Command History
Release 4.1
Functional Notes
Crypto map entries do not directly contain the transform configuration for securing data. Instead, the crypto
map is associated with transform sets which contain specific security algorithms (see
transform-set <setname> <parameters>
If no transform set is configured for a crypto map, then the entry is incomplete and will have no effect on
the system. For manual key crypto maps, only one transform set can be specified.
Usage Examples
The following example first creates a transform set (Set1) consisting of two security algorithms (up to three
may be defined), and then assigns the transform set to a crypto map (Map1):
(config)#crypto ipsec transform-set Set1 esp-3des esp-sha-hmac
(cfg-crypto-trans)#exit
(config)#crypto map Map1 1 ipsec-manual
(config-crypto-map)#set transform-set Set1
61200990L1-35E
on page 329
Assigns a transform set to this crypto map by entering the set name.
Command was introduced.
on page 329
Copyright © 2005 ADTRAN
Crypto Map Manual Command Set
for information on defining transform sets.
).
crypto ipsec
1062