T3 Interface Configuration Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
T3 I
NTERFACE
To activate the T3 Interface Configuration mode, enter the interface t3 command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface t3 1/1
(config-t3 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
clock source [local | loop]
coding [b3zs] on page 622
framing [m13 | cbit]
line-length [short | long]
loopback network [line | payload]
loopback remote [line | payload]
remote-loopback on page 627
show [bert] on page 628
snmp trap link-status
test-pattern [clear | insert | ones | p215 | p223 | zeros]
61200990L1-35E
C
ONFIGURATION
on page 31
on page 621
on page 623
on page 624
on page 625
on page 626
on page 629
Copyright © 2005 ADTRAN

T3 Interface Configuration Command Set

C S
OMMAND ET
on page 630
620