Command Reference Guide
Usage Examples
In the following example, all BGP routes are displayed whose community numbers match those listed in
the show ip bgp community command.
>enable
#show ip bgp community local-as 10:405
BGP local router ID is 10.22.131.241, local AS is 302.
Status codes: * valid, > best, i - internal, o - local
Origin codes: i - IGP, e - EGP, ? - incomplete
Network
10.22.152.20/30
10.22.152.24/29
10.22.152.36/30
10.22.152.52/30
11.0.0.0/30
12.0.0.0/30
13.0.0.0/30
14.0.0.0/30
20.0.0.0/30
21.0.0.0/30
Total RIB entries = 10
Information displayed includes: the ID of this router and its Autonomous System (AS) number; the
destination Network address of the route learned; the Next Hop address to that network; the Metric; the
Local Preference value (set using the set local-preference command); and the AS Path to the destination
network.
The following is a sample output for the show-ip bgp community command with an exact match specified:
BGP routes with the community numbers specified and only those specified are shown
>enable
#show ip bgp community 1001 2001 3001 exact
BGP local router ID is 192.168.9.1, local AS is 252.
Status codes: * valid, > best, i - internal, o - local
Origin codes: i - IGP, e - EGP, ? - incomplete
Network
* 192.168.11.0/24
* 192.168.12.0/24
*> 192.168.32.0/24 10.22.27.249
*> 192.168.33.0/24 10.22.27.249
Total RIB entries = 4
61200990L1-35E
Next Hop
Metric
10.22.131.10
304
10.22.131.10
304
10.22.131.10
304
10.22.131.10
304
10.22.131.10
304
10.22.131.10
304
10.22.131.10
304
10.22.131.10
304
10.22.131.10
304
10.22.131.10
304
NextHop
Metric
10.22.27.251
10.22.27.251
Copyright © 2005 ADTRAN
Enable Mode Command Set
LocPrf
Path
302 300 1 3 4 i
302 300 1 3 4 5 i
302 300 1 3 4 i
302 300 1 3 4 i
302 300 1 3 4 6 i
302 300 1 3 4 6 i
302 300 1 3 4 6 i
302 300 1 3 4 6 i
302 300 1 3 4 5 i
302 300 1 3 4 5 i
LocPrf
Path
249 251 i
249 251 i
249 i
249 i
191