Health Threshold - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

health threshold

health threshold
Configures thresholds for input traffic (RX), output/input traffic (TX/RX), memory usage, CPU usage, and
chassis temperature.
Input traffic, output/input traffic, memory usage, and CPU usage thresholds specify the maximum
percentage for each resource that may be consumed before a trap is sent to the user. The temperature
threshold specifies the maximum operating temperature, in Celsius, allowed within the chassis before a
trap is sent.
health threshold {rx percent | txrx percent | memory percent | cpu percent }
Syntax Definitions
rx
txrx
memory
cpu
percent
degrees
Defaults
parameter
percentage
degrees
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
When a resource falls back below the configured threshold, an additional trap is sent to the user. This
indicates that the resource is no longer operating beyond its configured threshold limit.
•
Changing a threshold value sets the value for all levels of the switch (the switch, module, and port).
You cannot set different threshold values for each level.
•
For detailed information on each threshold type, refer to
"Diagnosing Switch Problems" in your Network Configuration Guide.
•
To view the current health threshold values, use the
page 36-2
Specifies the maximum input (RX) traffic threshold.
Specifies the maximum output/input (TX/RX) traffic threshold.
Specifies the maximum RAM memory usage threshold.
Specifies the maximum CPU usage threshold.
The new threshold value, in percent, for the corresponding resource—
rx, txrx, memory, cpu—(0–100).
The new threshold value, in Celsius, for the chassis temperature
threshold (0–100).
default
80
50
show health configuration
Health Monitoring Commands
page 36-5, or refer to the chapter titled
command.
OmniSwitch CLI Reference Guide March 2011