Cargo Bed Damper Removal/Installation; Cargo Bed Damper Disassembly/Assembly; Bed Side Panel - Honda MUV700 big red Service Manual

FRAME/BODY PANELS/EXHAUST SYSTEM
REMOVALIINSTALLA TION
Remove the wire band from the bed frame
and disconnect the brake/taillight 6P (black)
connector.
Remove the bed damper (page 3-16).
Remove the two mounting nuts and bolts.
While holding on to the bed frame and being
careful not to damage the brake/taillights and
release lever, remove the cargo bed. Set the
cargo bed down on its bed frame.
Make sure
rhe Installation is in the reverse order of removal.
rubber mounts on
the chassis frame
are
In
poSition
and
in good condItIOn
DISASSEMBLY/ASSEMBLY
BED SIDE PA NEL
Remove the following:
- trim clip
- four bolts and collars
- bed side panel
Installation is in the reverse order of remova l .
)
CARGO BED
~
TRIM CUP
(
o
BOLTSAND~
COLLARS
(
...
, '
..
3-17