Web Interface Configuration; Configuring The Nsm Software - Juniper NETWORK AND SECURITY MANAGER NSM3000 - QUICK START REV 1 Quick Start Manual

NSM3000 Quick Start

Configuring the NSM Software

8
Enter the IP address for interface eth0 and press Enter.
1.
Enter the subnet mask for interface eth0 and press Enter.
2.
Enter the default route or default gateway address for interface eth0 and press Enter.
3.
Applying changes...
Re-loading database
ip_tables: (C) 2000 2002 Netfilter core team
ip_tables: (C) 2000 2002 Netfilter core team
ip_tables: (C) 2000 2002 Netfileter core team
Done!
Your NSMXpress is now active on the network.
To configure your system via a web browser, connect to:
https://10.150.43.205/administration
To configure your system via command line, type:
nsm_setup
For operation of NSM server, switch to user "nsm".
Please consult NSM product documentation for details.
[admin@NSMXpress ~]$
To configure the NSM software using the CLI, see the NSMXpress and NSM3000 User
Guide. To configure the NSM software using the Web interface, go to "Web Interface
Configuration" on page 8.

Web Interface Configuration

To configure NSM on your system from a Web interface, use the following steps.
Copy the URL (starting with
1.
NSM3000:
Your NSMXpress is now active on the network.
To configure your system via a web browser, connect to:
https//10.150.43.205/administration
Open a Web browser and paste the URL into the address text box.
2.
Press Enter to open the NSM appliance login page.
3.
Enter the admin user name and password and then click Login.
4.
See "Configuring the NSM Software" on page 8 for details about how to install and
5.
configure NSM on your NSM3000 appliance from the Web interface.
After you log in as an "admin" user, an initial setup script walks you through additional
configuration system settings before finalizing the NSM installation. This chapter describes
that setup process.
) from the terminal emulator after installing the
https://
Copyright © 2010, Juniper Networks, Inc.