Interface Gigabitethernet - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

interface gigabitEthernet

[ no ] interface gigabitEthernet interfaceSpecifier
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies or creates a Gigabit Ethernet interface or a subinterface over a Gigabit
Description
Ethernet interface. The no version removes the interface or subinterface.
NOTE: On the GE I/O module, you can configure only the primary port, 0. The router
automatically uses the redundant port, 0R, if the primary port fails.
On the GE-2 APS I/O module, you can configure only the primary ports, 0 and 1. The
router automatically uses the corresponding redundant port, 0R or 1R, if the primary
port fails.
On the OC3-2 GE APS I/O module, you can configure only a Gigabit Ethernet interface
in port 2. Ports 0 and 1 are reserved for OC3/STM1 ATM interfaces.
On the ES-2 GE-4 IOA, you can configure all four ports.
Options
Global Configuration
Mode
Related Topics
704
interface gigabitEthernet
interfaceSpecifier Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
Configuring the QoS Shaping Mode for Ethernet Interfaces
Creating a QoS Interface Hierarchy for Bulk-Configured VLAN Subinterfaces with
RADIUS
Configuring a Parameter Definition to Shape Ethernet Traffic Using Cell Mode