Grace-Period - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

grace-period

grace-period days [ hours [ minutes [ seconds ] ] ]
Syntax
no grace-period
Command introduced in JUNOSe Release 8.0.0.
Release Information
Configures the grace period for address leases allocated from the current DHCP local
Description
address pool. When the address lease expires, the address enters the grace period,
when the address continues to be unavailable to other clients and can only be
reassigned to the original client. This command applies only to expired releases to
optionally apply the grace period to addresses that are explicitly released by a client,
you must enable the use-release-grace-period command. The no version restores
the default, in which no grace period is associated with the local address pool.
Options
DHCP Local Pool Configuration
Mode
days Number of days in the grace period; in the range 0–32767
hours Number of hours in the grace period; in the range 0–23
minutes Number of minutes in the grace period; in the range 0–59
seconds Number of seconds in the grace period; in the range 0–59
Chapter 8: G Commands
653
grace-period