07/11/02 09:19:56 61TA0000_110_0401
28. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0443 indicated?
YES
−
Check for poor connections or loose
terminals at the EVAP canister purge valve and the
ECM/PCM, then go to step 1.
−
NO
Go to step 29.
29. Monitor the OBD STATUS for DTC P0443 in the
DTCs MENU with the HDS.
Does the screen indicate PASSED?
−
YES
Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 28,
go to the indicated DTC's troubleshooting.
NO
−
If the screen indicates FAILED, check for poor
connections or loose terminals at the EVAP canister
purge valve and the ECM/PCM, then go to step 1. If
the screen indicates EXECUTING, OUT OF
CONDITION, or NOT COMPLETED, keep idling until
a result comes on.
30. Reconnect all connectors.
31. Update the ECM/PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good ECM/PCM (see page 11-7).
32. Start the engine, and let it idle.
33. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0443 indicated?
−
YES
Check for poor connections or loose
terminals at the EVAP canister purge valve and the
ECM/PCM. If the ECM/PCM was updated, substitute
a known-good ECM/PCM (see page 11-7), then go
to step 32. If the ECM/PCM was substituted, go to
step 1.
−
NO
Go to step 34.
34. Monitor the OBD STATUS for DTC P0443 in the
DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES
−
If the ECM/PCM was updated,
troubleshooting is complete. If the ECM/PCM was
substituted, replace the original ECM/PCM
(see page 11-232). If any other Temporary DTCs or
DTCs were indicated in step 33, go to the indicated
DTC's troubleshooting.
NO
−
If the screen indicates FAILED, check for poor
connections or loose terminals at the EVAP canister
purge valve and the ECM/PCM. If the ECM/PCM
was updated, substitute a known-good ECM/PCM
(see page 11-7), then go to step 32. If the ECM/PCM
was substituted, go to step 1. If the screen indicates
EXECUTING, OUT OF CONDITION, or NOT
COMPLETED, keep idling until a result comes on.
11-401