Clutch Disc And Pressure Plate Installation - Honda Civic 2002-2003 Service Manual

Clutch
Clutch Replacement (cont'd)
Clutch Disc and Pressure Plate Installation
1. Temporarily install the clutch disc onto the splines
of the transmission mains haft. Make sure the clutch
disc slides freely on the mainshaft.
2. Install the ring gear holder.
07ZAF-PR8Al00
r
07936-3710100
IP/N 08798-90021
071AB-PV00100 or
07924-PD20003
B
3. Apply super high temp urea grease (PIN 08798-
9002) to the splines (A) of the clutch disc (B), then
install the clutch disc using the special tools.
4. Install the pressure plate (A) and the mounting
bolts (B) finger-tight.
B
12-12
5. Torque the mounting bolts in a crisscross pattern.
Tighten the bolts in several steps to prevent
warping the diaphragm spring.
PRESSURE PLATE MOUNTING BOLT TORQUE:
25 N-m (2_6 kgf·m, 19Ibf·ft)
6. Remove the special tools.
7. Make sure the diaphragm spring fingers are all the
same height.