07/11/02 09:19:19 61TA0000_110_0400
EVAP System
DTC Troubleshooting (cont'd)
21. Check for continuity between ECM/PCM connector
terminal B3 and EVAP canister purge valve 2P
connector terminal No. 2.
*05
EVAP CANISTER PURGE VALVE 2P CONNECTOR
Wire side of female terminals
PCS (YEL/BLU) ECM/PCM CONNECTOR B (49P)
Is there continuity?
YES
NO
−
canister purge valve and the ECM/PCM (B3), then
go to step 24.
11-400
PCS (YEL/BLU)
Terminal side of female terminals
−
Go to step 22.
Repair open in the wire between the EVAP
22. At the valve side, measure resistance between
EVAP canister purge valve 2P connector terminals
No. 1 and No. 2.
EVAP CANISTER PURGE VALVE 2P CONNECTOR
Terminal side of male terminals
Is there about 23 26
−
at room temperature?
−
YES
Go to step 30.
NO
−
Go to step 23.
23. Replace the EVAP canister purge valve (see page
11-431).
24. Reconnect all connectors.
25. Turn the ignition switch to ON (II).
26. Reset the ECM/PCM with the HDS.
27. Do the ECM/PCM idle learn procedure (see page
11-343).
*06