Delta ASDA-A3 Series User Manual page 4

Operation
Before operating the machine, change the servo parameter setting according to the
◼
application. If the parameters are not adjusted to the correct values, it may lead to
malfunction of the machine or the operation might be out of control.
◼ Ensure you can activate the emergency stop before operating the machine.
◼ When applying power, make sure the motor is not rotating because of inertia of the
machine or other causes.
During the operation, do not touch any rotating motor parts, or it may cause personnel injury.
◼ To avoid accidents, remove all units during the first test run, so that the motor is operating
without any load.
◼ If you fail to operate the servo motor properly after it is connected to the equipment, it may
damage the equipment and lead to personnel injury.
◼ In order to prevent danger, it is strongly recommended that you check if the servo motor
can operate normally without load first. Then, try operating the motor with load.
◼ Do not touch the heat sink of the servo drive during operation, or it may cause burns.
Maintenance and inspection
◼ Do not touch the internal parts of the servo drive and servo motor, or it may cause electric
shock.
◼ Do not disassemble the servo drive panel when the power is on, or it may cause electric
shock.
◼ Do not touch the ground terminal within 10 minutes after turning off the power, or the
residual voltage may cause electric shock.
Do not disassemble the motor, or it may cause electric shock or personnel injury.
◼
Do not change the wiring when the power is on, or it may cause electric shock or
◼
personnel injury.
◼ Only qualified electricians can install, wire, and maintain the servo drive and servo motor.
iii