Delta ASDA-A3 Series User Manual page 653

Parameters

X: setting for position command issued by the analog signal
0: disable
1: enable
8

Y: initial position setting
0: after the servo is on, the motor regards the current position as the position when the voltage is
1: after the servo is on, if the command level is not changed, the motor does not operate. The
P1.065
Default: 1
Format: DEC
Settings:
The smooth constant of analog Position command is only effective to analog Position command.
8-76
0V. Then the motor operates to the corresponding position according to the analog input
command.
position the motor stops at is the position corresponding to the current command level.
Analog Position command - smoothing constant
Unit: 10 ms
Control mode: PT
Setting range: 1 to 1000
Data size: 16-bit
ASDA-A3
Address: 0182H
0183H