Delta ASDA-A3 Series User Manual page 673

Parameters

Z: input contact: A or B contact
0: set this input contact to be normally closed (B contact)
1: set this input contact to be normally open (A contact)
8
When these parameters are modified, re-start the servo drive to ensure it functions normally. Use
P3.006 to change the source for the digital input signal, which can be either an external terminal block
or the communication parameter P4.007.
P2.011
Default:
Format: HEX
Settings:
Refer to the description of P2.010.
P2.012
Default:
Format: HEX
Settings:
Refer to the description of P2.010.
P2.013
Default:
Format: HEX
Settings:
Refer to the description of P2.010.
P2.014
Default:
Format: HEX
Settings:
Refer to the description of P2.010.
8-96
DI2 functional planning
0x0104 (A3-L, A3-M)
0x0100 (A3-F, A3-E)
Unit: -
DI3 functional planning
0x0116 (A3-L, A3-M)
0x0100 (A3-F, A3-E)
Unit: -
DI4 functional planning
0x0117 (A3-L, A3-M)
0x0124 (A3-F, A3-E)
Unit: -
DI5 functional planning
0x0102 (A3-L, A3-M)
0x0022 (A3-F, A3-E)
Unit: -
Control mode: All
0x0000 - 0x015F (last two codes
Setting range:
are DI codes)
Data size: 16-bit
Control mode: All
0x0000 - 0x015F (last two codes
Setting range:
are DI codes)
Data size: 16-bit
Control mode: All
Setting range: 0x0000 - 0x015F (last two codes
are DI codes)
Data size: 16-bit
Control mode: All
Setting range: 0x0000 - 0x015F (last two codes
are DI codes)
Data size: 16-bit
ASDA-A3
Address: 0216H
0217H
Address: 0218H
0219H
Address: 021AH
021BH
Address: 021CH
021DH