Delta ASDA-A3 Series User Manual page 730

ASDA-A3
P4.007■
Default: 0x0000
Unit: -
Format: HEX
Settings:
The source of the DI input signal can be the external terminal (DI1 - DI5) or the software (SDI1 - SDI5
corresponding to Bits 0 - 4 of P4.007), which is determined by P3.006. If the corresponding bit of P3.006
is 1, which means the source is the software SDI (P4.007); if the corresponding bit is 0, then the source
is the hardware DI. See the following figure:
Read parameters: shows the DI status after combining external DI and software SDI.
Write parameters: writes the software SDI status. This function is the same whether you use the panel or
communication to set the parameter.
For example: if the read value of P4.007 is 0x0011, it means DI1 and DI5 are on; if the value written to
P4.007 is 0x0011, it means the software SDI1 and SDI5 are on. Refer to P2.010 - P2.014 for more
information on digital input functional planning (DI1 - DI5).
P4.008★
Default: -
Unit: -
Format: HEX
Settings:
Read this parameter through communication and check if the five keys (MODE, UP, DOWN, SHIFT, and
SET) can function normally.
P4.009★
Default: -
Unit: -
Format: HEX
Settings:
There is no difference either reading by panel or through communication.
Multi-function for digital input
Input status of servo drive panel (read-only)
Digital output status (read-only)
Control mode: All
Setting range: 0x0000 - 0x3FFF
Data size: 16-bit
Control mode: All
Setting range: Read-only
Data size: 16-bit
Control mode: All
Setting range: 0x0000 - 0x001F
Data size: 16-bit
Parameters
Address: 040EH
040FH
Address: 0410H
0411H
Address: 0412H
0413H
8
8-153