ASDA-A3
8.3 Parameter descriptions
P0.xxx Monitoring parameters
P0.000★
Default: Factory setting
Unit: -
Format: DEC
Settings:
Displays the firmware version of the servo drive.
P0.001■
Default: -
Unit: -
Format: HEX
Settings:
For the list of alarms, refer to Section 14.1 Alarm list.
P0.002
Default: 1
Unit: -
Format: DEC
Settings:
Input the monitoring code to P0.002 to view changes to the variable on the panel. For the list of
monitoring variables, refer to Table 8.3 Monitoring variables descriptions.
P0.003
Default: 0x0000
Unit: -
Format: HEX
Settings:
UZ
Y
Firmware version
Current drive alarm code (seven-segment display)
Drive status
Analog output monitoring
X
Control mode: All
Setting range: -
Data size: 16-bit
Control mode: All
0x0000: alarm clear (same as
DI.ARST).
Setting range:
0x0001 - 0xFFFF: displays the
alarm code (not writable).
Data size: 16-bit
Control mode: All
Setting range: -300 to +127
Data size: 16-bit
Control mode: All
Setting range: 0x0000 to 0x0077
Data size: 16-bit
Parameters
Address: 0000H
0001H
Address: 0002H
0003H
Address: 0004H
0005H
Address: 0006H
0007H
8
8-25