Delta ASDA-A3 Series User Manual page 733

Parameters
P4.018
Default: Factory setting
8
Format: DEC
Settings:
Manually calibrate the hardware offset. The function must be enabled by setting P2.008. Do not change
the auxiliary calibration as this parameter cannot be reset.
P4.019
Default: Factory setting
Format: DEC
Settings:
Cool down the drive to 25°C (77°F) before calibration. The function must be enabled by setting P2.008.
P4.020
Default: 0
Format: DEC
Settings:
Manually adjust the compensation value for the offset (cannot reset). The function must be enabled by
setting P2.008.
P4.021
Default: 0
Format: DEC
Settings:
Manually adjust the compensation value for the offset (cannot reset). The function must be enabled by
setting P2.008.
8-156
Current detector (W2 phase) - hardware offset calibration
Unit: -
IGBT NTC calibration level (cannot reset)
Unit: -
Analog monitor output (Ch1) - offset compensation value
Unit: mV
Analog monitor output (Ch2) - offset compensation value
Unit: mV
Control mode: All
Setting range: 13926 to 18842
Data size: 16-bit
Control mode: All
Setting range: 1 to 4
Data size: 16-bit
Control mode: All
Setting range: -800 to +800
Data size: 16-bit
Control mode: All
Setting range: -800 to +800
Data size: 16-bit
ASDA-A3
Address: 0424H
0425H
Address: 0426H
0427H
Address: 0428H
0429H
Address: 042AH
042BH