Delta ASDA-A3 Series User Manual page 121

Wiring
100 W - 3 kW servo drives – Crimping for wire ferrules
 Use a ferrule with the barrel length of 12 mm (0.47 inches) and the wires of corresponding
3
specifications for the drives. If the barrel length is shorter than 12 mm, the wire may fall off
and cause danger.
 Use a ferrule crimper to properly crimp the barrel and wires.
 Do not use bare wires for wiring, or the loose wires may cause accidents.
3-40
Step 1: cut through the insulation layer to
expose the lead wire for more than 15 mm
(0.59 inches).
Step 2: insert the wire into the ferrule.
Step 3: use a ferrule crimper to crimp the
barrel. Cut off the exposed lead wire; the
remaining length of the exposed wire should
be shorter than 0.5 mm (0.02 inches).
ASDA-A3