ASDA-A3
10.2.2 Installing and replacing batteries
Single battery box
Step 1:
Release the snap-fit tabs on both sides and
remove the battery box cover.
Step 2:
Position the cable clamp to the encoder
cable. Note that the cable clamp should be
placed close to the heat shrink.
(A) Cable clamp; (B) Heat shrink
Step 3:
Plug in the battery box cable and tighten the
cable clamp screw.
Step 4:
Install a new battery and plug in the battery
connection wire.
(C) Replace the battery only when the main
power to the servo drive is on. Do not
remove the battery box cable which connects
to the servo drive, or else the system may
lose data.
Step 5:
Place the battery connection wire into the
box and fit the cover.
Absolute System
10
10-15