Checking The Hall Sensor Phase Sequence - Delta ASDA-A3 Series User Manual

ASDA-A3 Linear Motor and Third-Party Motor

11.5.2 Checking the Hall sensor phase sequence

To check the phase sequence of the Hall sensor, set P0.017 to the monitoring variable -177 and
observe the change of phase sequence with P0.009. The bits of this monitoring variable are
11
(bit 3, bit 2, bit 1) = (W, V, U). The following figure shows the waveform monitored by the scope
when you manually move the linear motor. You can see the phase sequence in the cycle of
(1, 0, 1), (1, 0, 0), (1, 1, 0), (0, 1, 0), (0, 1, 1), and (0, 0, 1). When the motor reverses, the phase
sequence is also reversed. Incorrect phase sequence may cause the motor to go in the wrong
direction or even be out of control.
Note: for the monitoring variable -177, Bit 1 represents U phase, Bit 2 represents V phase, and Bit 3
represents W phase.
(1,1,0)
(1,0,1)
(1,0,0)
(0,1,1)
(0,1,0)
(0,0,1)
11-33