Show Ip As-Path-List Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show ip as-path-list [<listname>]
Use the show ip as-path-list command to display any AS path lists that have been configured in the router,
along with any permit and deny clauses in each list.
Syntax Description
<listname>
Default Values
By default, this command displays all AS path lists.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 10.1
Usage Examples
In the following example, all AS path lists defined in the router are displayed.
>enable
#show ip as-path-list
ip as-path-list AsPathList1:
permit 100
permit 200
permit 300
deny 6500
ip as-path-list AsPathList2:
permit 400
permit 500
In the following example, only the AS Path List with the name AsPathList2 is displayed.
>enable
#show ip as-path-list AsPathList2
ip as-path-list AsPathList2:
permit 400
permit 500
61200990L1-35E
Optional. Specifies that the command display only the list matching the specified
AS path listname. If not specified, all AS path lists are displayed.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
189