Show Auto-Config Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show auto-config
Use the show auto-config command to display auto-configuration status.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following is a sample output of the show auto-config command:
>enable
#show auto-config
Auto-Config is enabled, current status: Done.
TFTP Server is 10.20.20.1
Config filename is 1524STfile
Maximum retry count is 0 (repeat indefinitely), total retries is 0
61200990L1-35E
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
154