Show Frame-Relay Fragment Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show frame-relay fragment [frame-relay <port.sublink>]
Use the show frame-relay fragment command to display FRF.12 statistics for Frame Relay sublinks
enabling FRF.12 fragmentation.
Syntax Description
frame-relay <port.sublink>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 6.1
Usage Examples
The following are sample outputs from various show frame-relay fragment commands:
>enable
#show frame-relay fragment
interface dlci
fr 1.1 17
fr 1.2 18
>enable
#show frame-relay fragment frame-relay 1.1
DLCI = 17 FRAGMENT SIZE = 100
rx frag. pkts
rx frag. bytes
rx non-frag. pkts
rx non-frag. bytes
rx assembled pkts
rx assembled bytes
dropped reassembling pkts
rx out-of-sequence fragments
rx unexpected beginning fragment
61200990L1-35E
Optional. Displays detailed FRF.12 statistics for the specified Frame Relay
sublink (if FRF.12 is enabled on that sublink).
Command was introduced.
frag_size rx_frag
100 46
200 42
46 tx frag. pkts
4598 tx frag. bytes
18 tx non-frag. pkts
1228 tx non-frag. bytes
23 tx pre-fragment pkts
5478 tx pre-fragment bytes
0 dropped fragmenting pkts
0
0
Copyright © 2005 ADTRAN
Enable Mode Command Set
tx_frag
48
21
48
4724
28
1960
34
6324
0
dropped_frag
0
0
178