Show Crypto Ike Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show crypto ike
Use the show crypto ike command to display information regarding the IKE configuration.
Variations of this command include the following:
show crypto ike client configuration pool
show crypto ike client configuration pool <poolname>
show crypto ike policy
show crypto ike policy <policy priority>
show crypto ike remote-id <remote-id>
show crypto ike sa
Syntax Description
client configuration pool Displays the list of all configured IKE client configuration pools.
<poolname>
policy
<policy priority>
remote-id <remote-id>
sa
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
61200990L1-35E
Displays detailed information regarding the specified IKE client configuration
pool.
Displays information on all IKE policies. Indicates if client configuration is
enabled for the IKE policies and displays the pool names.
Displays detailed information on the specified IKE policy. This number is
assigned using the crypto ike policy command. Refer to
322
for more information.
Displays information on all IKE information regarding the remote-id. The
remote-id value is specified using the crypto ike remote-id command (refer
to crypto ike remote-id
Displays the configuration of active IKE security associations.
Command was introduced.
Copyright © 2005 ADTRAN
on page 326 ).
Enable Mode Command Set
crypto ike on page
164