Show Crypto Map Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show crypto map
Use the show crypto map command to display information regarding crypto map settings.
Variations of this command include the following:
show crypto map
show crypto map <interface>
show crypto map <map name>
show crypto map <map name> <map number>
Syntax Description
<interface>
<map name>
<map number>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
Usage Examples
The following is a sample from the show crypto map command:
> enable
#show crypto map testMap
Crypto Map "testMap" 10 ipsec-ike
Extended IP access list NewList
Peers:
63.97.45.57
Transform sets:
esp-des
Security-association lifetimes:
0 kilobytes
86400 seconds
No PFS group configured
Interfaces using crypto map testMap:
eth 0/1
61200990L1-35E
Displays the crypto map settings for the specified interface. Type show
interfaces ? for a complete list of valid interfaces.
Specifies a specific crypto map name.
Specifies a specific crypto map number.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
167