Debug Ip Tcp Md5 Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Enable Mode Command Set
debug ip tcp md5
Use the debug ip tcp md5 command to activate debug messages that detail the results of each incoming
Transmission Control Protocol (TCP) packet's MD5 authentication with an internal route in the AOS.
Debug messages are displayed (real time) to the terminal (or Telnet) screen. Use the no form of this
command to disable the debug messages.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 9.1 Command was introduced.
Functional Notes
Debug messages will only be generated for TCP ports that have MD5 authentication enabled.
Usage Examples
The following example activates debug messages associated with incoming TCP packet's MD5 authentication:
>enable
#debug ip tcp md5
61200990L1-35E Copyright © 2005 ADTRAN 126