Debug Ip Pim-Sparse Joinprune Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
debug ip pim-sparse joinprune [event | state] <address>
Use the debug ip pim-sparse joinprune command to display protocol-independent multicast (PIM)
sparse mode join and prune transactions. Debug messages are displayed (real time) to the terminal (or
Telnet) screen. Use the no form of this command to disable debug messages.
Syntax Description
event
state
<address>
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 2000, 5000, and Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example activates PIM sparse mode messages for all join and prune events and state
changes:
>enable
#debug ip pim-sparse joinprune
61200990L1-35E
Displays PIM sparse join and prune events.
Displays PIM sparse join and prune state changes.
Specifies group address to filter.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
119