Debug Spanning-Tree Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
debug spanning-tree [config | events | general | root]
Use the debug spanning-tree command to enable the display of spanning-tree debug messages. Debug
messages are displayed (real time) on the terminal (or Telnet) screen. Use the no form of this command to
disable the debug messages.
Syntax Description
config
events
general
root
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1
Usage Examples
The following example enables the display of general spanning-tree debug messages:
>enable
#debug spanning-tree general
61200990L1-35E
Enables the display of spanning-tree debug messages when configuration
changes occur.
Enables the display of debug messages when spanning-tree protocol events
occur.
Enables the display of general spanning-tree debug messages.
Enables the display of debug messages related to the spanning-tree root.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
137